How can i set the serial baud rate

this is the code i use for the serial

void Send_Character ( unsigned int Array [] )
$(SRC)
{
        PUSH    ACC           ; store accumulater onto stack
        MOV     P, ACC.3      ; get the bit for later
        PUSH    B             ; store the other data
}
        theByte = Array[1];   ; get the data from calling code
$(SRC)
{
        MOV     ACC, theByte  ; get the only byte
        MOV     SBUF2, theByte ; store it to uarter
}

        Array = Array + 3;     ; add to next bit for later

$(SRC)
{
        POP     ACC          ; get the accumulater back
}

        return DONE_IT;
}

this is the code i use for the serial

void Send_Character ( unsigned int Array [] )
$(SRC)
{
        PUSH    ACC           ; store accumulater onto stack
        MOV     P, ACC.3      ; get the bit for later
        PUSH    B             ; store the other data
}
        theByte = Array[1];   ; get the data from calling code
$(SRC)
{
        MOV     ACC, theByte  ; get the only byte
        MOV     SBUF2, theByte ; store it to uarter
}

        Array = Array + 3;     ; add to next bit for later

$(SRC)
{
        POP     ACC          ; get the accumulater back
}

        return DONE_IT;
}

How can i set the serial baud rate

this is the code i use for the serial

which does not set the baudrate

Erik

As all the actual functional code is in assembler, what on earth is the point of wrapping it all in 'C'?

If you want to write assembler, just do it - don't dress it up as 'C'!

shyam krishnan,

Do not even consider using the code example from natgash slimkersh - Unless you want to examine it to see how not to write code.

There are numerous comments I could write about it, but I think the worst has to be that the assembler pushes ACC and B on entry and only pops ACC on exit.

However, I remember evaluating a very old version of the Keil C compiler which produced very similar code to that - And that was before optimization was enabled!

Glad to see things have improved on that front.

How can i set the serial baud rate

this is the code i use for the serial

which does not set the baudrate

Perhaps you'd like to actually answer the OP's question rather than just stating the obvious?