hi all.. i am using a philips p89v51rd2bn uc.i want to control a servo motor using an rf link.the pwm signal is being generated using a 555 timer and the uc at the transmitter end measures the pulse width using the pca module.now i want to send this measured pulse width to anoder uc at the recieveing end to control the servo.the pulse measured is in 16 bits and the servo control is only of 8 bits in pca module...i confused wether this will work at all...if yes..plzz gimme some suggestions...
Dude..its more like I save 10 seconds writing gibberish...and only YOU spend 25 seconds trying to figure it out...u(you) make me feel like i write complicated algos(oops...algorithms...sorry) like John Nash and leave them for you to decode...well..i wud have paid you if tat was the case...neways dude...i can still pay you to shut up..because everytime you write these kind of posts in a thread...then 100 people waste 10secs each when they come across your countless useless posts...and eventually they just skip your post when they read your name...you might wanna work on that... and hey, I hope my language was right in this post...
Erik
I thought so..
Thank you. But I need ready and tested routines for slow frequence (31kHz, 125kHz, 250kHz etc.).