This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Contents missmatch at: 00100000H ! for AT91SAM9260

Hi,

I am new to embedded system.
I am using AT91SAM9260 controller.
Please find below the error i am facing, while downloading the image to flash.

Erase Done.
Programming Done.
Contents missmatch at: 00100000H !
verify failed.

The linker script options are:

*.o --device DARMATS9 --ro-base 0x00100000 --entry Reset_Handler --rw-base 0x00200000 --first Reset_Handler --strict --autoat --summary_stderr --info summarysizes --map --xref --callgraph --symbols
--info sizes --info totals --info unused --info veneers --list ".\firstsc.map"
-o "firstsc.axf"

Also, the Jumper NANDF_E is left open while DF_E is closed.

Thanks in Advance,
Rudradev AC

Parents

0 Rudradev Ariyur over 17 years ago in reply to ImPer Westermark

Yes, you may be right.
Yes the Addresses are quite fine.
Since i am new to this domain, i am unable to rectify it. Trying to get help from SKPANK(board distributor), still waiting for a reply.

Thanks for the reply.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Rudradev Ariyur over 17 years ago in reply to ImPer Westermark

Yes, you may be right.
Yes the Addresses are quite fine.
Since i am new to this domain, i am unable to rectify it. Trying to get help from SKPANK(board distributor), still waiting for a reply.

Thanks for the reply.
Cancel
Vote up 0 Vote down

Cancel

Children

No data