Dear All,
I work on STM32F101V8 uC. I'm faced with a strange phenomenon related with burning. Once I downloaded a new firmware version to Flash and then started the program running by starting Debug Session in the uVision IDE, the program will continue to run if I close the Debug session or even if I physically disconnect the JTAG cable from my board. But if I want the program to start independently after the burning without JTAG's help, it does not work ! I tried to burn the firmware with J-FLASH of Segger as well, but the I have received the same result.
Can anybody explain me, please, what's going on here ?
Thanks in advance, Eli.