Creating a library (*.LIB)

Again, if you had made clear in your question that you were not using the GUI, I wouldn't have made that comment to you.
Note that it's substantially the same as the comment from Hans-Bernhard Broeker.

Now that we know that you're not using the GUI, clearly that comment doesn't apply to you - but your original question still doesn't give any indication that you'd made much effort with the manuals, does it?

Unfortunately, there are all too many examples on this forum where people are using the GUI and yet still ask the same question...

Again, if you had made clear in your question that you were not using the GUI, I wouldn't have made that comment to you.
Note that it's substantially the same as the comment from Hans-Bernhard Broeker.

Now that we know that you're not using the GUI, clearly that comment doesn't apply to you - but your original question still doesn't give any indication that you'd made much effort with the manuals, does it?

Unfortunately, there are all too many examples on this forum where people are using the GUI and yet still ask the same question...

Unfortunately, there are all too many examples on this forum where people are using the GUI and yet still ask the same question...
methinks that is due to "too many examples" of people that skip "crawl, then walk, then .." but go directly to 'run'. That is a known method for breaking a leg. Of course, the first you do after breaking a leg is to holler 'help'

Erik

1. I posted a vague question
2. Andy was sarcastic and rude
3. Erik tried to help and then misunderstood
4. For reply #10 I don't have much to say
5. Andy apologized in some way
6. And I am apologizing too

(Sorry and thanks guys)

Now that it is all clear

Lets enjoy n Happy New year!!

We are (or at least have been) enjoying a great New Year!

One method often used by people who prefer make files is to open the GUI tool once, and perform a full build. Some GUI have an option to export the project to a Makefile, but most other GUI still allow you to see the command lines run, allowing the user to see all relevant command line steps and options needed to build a project.

"Some GUI have an option to export the project to a Makefile"

Not uVision.

:-(

But uVision does have the option to export to a Batch file - which would still show all the relevant steps, command-lines, etc.

The uVision dialogues also show the resulting command lines, and I think all of the tool listing files show the command-line options used...

http://www.keil.com/support/man/docs/lib51/lib51_intro.htm