This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

I2C

HI Friends,

I am using P89LPC936 MCU for my project. Using >2 slaves. How can I send a info to particular slave with my C programming. Any sample codes. I want send to the 1st slave then followed by the next slave.

Thanks,

K. Saravanan

Parents

0 Andy Neil over 17 years ago

That's wat the Slave Address is for...
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Andy Neil over 17 years ago

That's wat the Slave Address is for...
Cancel
Vote up 0 Vote down

Cancel

Children

0 SARAVANAN KANNAN over 17 years ago in reply to Andy Neil

HI Thanks,

But how it's works any example. codes or etc..

Thanks...
Cancel
Vote up 0 Vote down

Cancel
0 Andy Neil over 17 years ago in reply to SARAVANAN KANNAN

http://www.keil.com/download/list/c51.htm

www.nxp.com/.../P89LPC933FDH.html
Cancel
Vote up 0 Vote down

Cancel
0 Andy Neil over 17 years ago in reply to Andy Neil

www.standardics.nxp.com/.../
Cancel
Vote up 0 Vote down

Cancel
0 erik malund over 17 years ago in reply to Andy Neil

why not use the CodeArchitect, free from http://www.esacademy.com it will do it all (OK 935/1000) for you.

Erik
Cancel
Vote up 0 Vote down

Cancel