Hello! My last thread was the N. 11275, but I post some other in the past for Mon166 on Infineon 167. I've a problem using Mon166 and I'm not able to solve it. I wrote to Technical support, but no answers at the moment. Is there anybody able to solve my problem?
Reading the first messages in this forum I understand that there are many questions and very little answers. The most of the answers says: - Check the file README.TXT - Check Chapter 11 of "Getting Started and Create Applications" These two documents says obvious things but cannot help to solve any problem. Is Mon166 configuration Top Secret?
after many times I've successfully configured Mon166 to start my debug.
Well done!
Starting from this example my configuration becomes OK. If I was most able, I would check previously some examples. Sorry, if possible I will not send other posts to this forum.
I did read your original thread. We succesfully got the monitor up and running in bootstrap mode. It's not a secret but it's not a trivial issue either.
You're welcome to ask anything (Keil related) on this forum but you can not expect people to invest hours and hours to get your monitor up and running, it's a complex task. You said you contacted Keil support and that's the best way to solve bigger tasks like this.
The monitor comes with examples, if you're able to get them running, you're own application should not be a problem. But then again, I do believe you should have asked the supplier that produced the firmware to release the monitor configuration as well... (why didn't they if they do sell/give you a whole firmware app + source code??)
Kind regards, Joost Leeuwesteijn
See also:
http://www.keil.com/support/docs/2277.htm
http://www.keil.com/c166/faq.asp -> monitor