Hi,
I have a Philips RD2 board with a memory mapped 8255 with ports A at 8000H, B at 8001H, C at 8002H and a control port at 8003H.
How do I set up my defines so that I can just refer to these memory mapped ports as PORTA, CTRLPRT etc. in a C program?
Muz
I should have a couple of those about 20 years below the dust :)
when the 8255 was 'standard', every darn thing you made had to be 'tuned' except, of course, those with the psd chips instead. I believe I still have scars from touching the original 'steam driven' '51s oh how Impressed I was about their screaming 8 MHz performance. ICEs were complicated, the '51s were dynamic and could not be stopped without 'losing their mind'. Oh, you young whippersnappers, you have an easy life.
These days, with modern devices, I am almost in the opposite ditch, things work so seamlessly that I almost get surprised when checking timings show anything but "this will work with a wide tolerance".
Erik
It appears that he is trying to emulate a DOS driven AT port for a DIO board using the 8051. Suggest that you do a inet search on DIO boards. I'm sure that you will find some old documentation with timing demonstrated. By the way Erik, you are not the oldest timer here. I first started on computers when John von Neumann was still alive. Of course we called him Janci. Just not digital computers for me at the time. ;-). Bradford
By the way Erik, you are not the oldest timer here well, since I do not know your age, and you do not know mine I can't argue the point. However, we both, evidently, have ages of experience. When I went to college the main electronic component was somewthing called 'tubes' or 'valves' and after collegte I was involved with making the first transistor radio made in Denmark.