This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Duty Cycle Control

Hi everyone,

I am using XC164CS DSP. I need to programme in such a way that duty cycle can be controlled. According to application, its a close loop current or voltage control but I didnt manage to do it in order to get the phase shift between the two legs of the converter. I need to get the phase shift by calculating duty cycle. it's a 20khz frequency of the signal

Can anyone help me on this?

Thanks,

Vivek

Parents

0 Chris Wunderlich over 17 years ago in reply to Vivek Tailor

You can find an example to create a PWM using CAPCOM6 that you can modify the duty-cycle or period.

http://www.keil.com/forum/docs/thread11620.asp

hope this helps.

-Chris
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Chris Wunderlich over 17 years ago in reply to Vivek Tailor

You can find an example to create a PWM using CAPCOM6 that you can modify the duty-cycle or period.

http://www.keil.com/forum/docs/thread11620.asp

hope this helps.

-Chris
Cancel
Vote up 0 Vote down

Cancel

Children

No data