This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

lpc2132 doesn't respond me :(

Hello;

I am an almost a newbie on ARM/ I was trying to figure out how to configure a startup.s file. I worked on PLL settings a little and after that it started not to respond me. please note that I use different board and flash program (H-JTAG).

I have found that If I load a wrong pll settings , it won't respond me any longer until I load the correct settings manually.

Then, I tried to load correct setting via ISP. But whatever I have done , The micro doesn't enter the isp mode.

Thanks, Any help will be welcome

Adem

Parents
  • Wrong settings for the PLL is expected to not work. The processor just can't be trusted if overclocked.

    How can we help you with your ISP problems? You only say "But whatever I have done" but you don't actually tell us what you have done. Post what you have tried, and the results, and then we can respond.

Reply
  • Wrong settings for the PLL is expected to not work. The processor just can't be trusted if overclocked.

    How can we help you with your ISP problems? You only say "But whatever I have done" but you don't actually tell us what you have done. Post what you have tried, and the results, and then we can respond.

Children