Hello,
I have a problem with my project, the code is running fine when debugging, men will not execute stand alone.
This is proberly a neewbie issue, so please come with all your good / bad ideas :)
Kasper
Hello, thank you for your input.
I now came that long if i download the code with the ulink-me and disconnect it, turn off power and on power the board is not starting, after i make a reset on NRST the board starts up running the code fine.
How do i make the code start when i power up the device?
on NRST pin i have a 10K pull-up ressistor.
do i need to activate POR somewhere?