This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Programming AT89S52 using FLIP

Dear friends,

I am planning to develop my own AT89S52 development board having ISP facility using FLIP software.

While going through the documentation of Flip available on ATMEL's site, I could not find the description of programming cable. To be precise, I want to know the pin wise connection between the Parallel/Serial/USB port of the computer and that of the AT89S52.

Looking forward to your replies.

Akshay

Parents
  • While going through the documentation of Flip available on ATMEL's site, I could not find the description of programming cable. To be precise, I want to know the pin wise connection between the Parallel/Serial/USB port of the computer and that of the AT89S52
    there is logic (hidden) in the connector.
    I guess the most frequent post at sites dealing with this (it is not a keil issue) is "why does my homemade Arghmel ISP programming cable circuit not work".

    so my suggestion is buy the darn cable ($25)

    Erik

Reply
  • While going through the documentation of Flip available on ATMEL's site, I could not find the description of programming cable. To be precise, I want to know the pin wise connection between the Parallel/Serial/USB port of the computer and that of the AT89S52
    there is logic (hidden) in the connector.
    I guess the most frequent post at sites dealing with this (it is not a keil issue) is "why does my homemade Arghmel ISP programming cable circuit not work".

    so my suggestion is buy the darn cable ($25)

    Erik

Children
No data