With all respect of each and every one of you,who I know are the best on this(Andy Neil,Westermark,Erik Malund,Dan Henry)I would ask some advice.first I should said that I have read a lot of posters for about 3 weeks before.I understain that this forum is high class programmers and many of my questions could be offensive here,Im aware of this.my question is: CC1110Fx/CC1111Fx and CC1010 (8051) includes an on-chip debug module which communicates over a two-wire interface,I know that the debug interface allows programming of the on-chip flash also provides access to memory and registerscontents...what are my options if I haven't that flash programmer,depelopment kit from chipcon???How can I develop a code for CC1110 and cc1010??and even Basic code,does anyone know something about this?is so new that only professionals can get access to the maze of cc1110f32 and cc1010?without a products from chipcon (500 dollars)with some alternatives ways to get inside 8051 core ,the 2-wire debud interface created by myself,P2_1 (Debug Data)bi-directional and P2_2 input(Debug Clock) pins.Debug commands are sent by an external hostand consist of 1 to 4 output bytes (includingcommand byte) from the host and an optional input byte read by the host(status byte).using allready made programmers hardware more availables,external host,any idea?without ofcourse the SmartRF04EB ans the beauty of soft Smart RF studio from chipcon.Finnaly programming of the on-chip flash is performed (via the debug interface)the external host must initially send instructions using the DEBUG_INSTR debug command to perform the flash programming with the Flash Controller. I mean some people in India are looking on the garbagge,reusing Rfmodules from mouse,keyboards and toys and creating beautifull things,if they can?? Dmitry