This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Create the HEX file for internal and external Flash

S B over 17 years ago

I'm using the Keil C51 tools for a project I'm designing. I am using Atmel 89S52 device for my project.I wanted to use the internal 8K flash and external 64 KB flash for code.How i can create my hex file for these internal and external areas.where i will have to program this hex file. It will be in the external Flash?
What's the best way to go about this?

Parents

0 Shahul Hameed over 17 years ago

Hi simran,

start the address by the selection of your address lines.Also enable the W/R bit.It may be the solution.

Thanks

m.shahul@kone.com
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Shahul Hameed over 17 years ago

Hi simran,

start the address by the selection of your address lines.Also enable the W/R bit.It may be the solution.

Thanks

m.shahul@kone.com
Cancel
Vote up 0 Vote down

Cancel

Children

No data