We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Is this possible if we use hard reset (Logic 1 Pulse with some delay) by using ISR and one Port Pin Connected to RESET Pin? so that Controller can RESET itself by Applying RESET signal by ISR. I mean Software *** Hardware RESET!
AT89S52 can be reset with logic high for 2 machine cycles to RESET PIN. I used Proteus VSM 7.1 and it shows RESET... Reset itself by ISR and Port Pin
delay(); RESET_Port_Pin=1; //Soft Reset to uC by Port Pin delay(); RESET_Port_Pin=0; delay();
But in Actual Circuit this Doesn't works. Without any chip it could be done or not? I think momentry latching of some type will help? Please help!
How WDT will cause Overflow in that routine so that it can RESET uC AT89S52. i think it will take 16ms approx for 11.0592MHz, but it is still in while loop?
Thanx again Dan Henry!