This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PWM using CAPCOM1/2 in XC164CS

Hello,
Can anyone tell me if could be possible to create a differents PWM with variable duty cycle by using CAPCOM1/2?
How would you configure output pines? I have tried it in Dave, but I dont see.
Thanks.

Parents

0 John Brown over 17 years ago in reply to John Brown

It has it.I've noticed that the P9.4 had configured as general output.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 John Brown over 17 years ago in reply to John Brown

It has it.I've noticed that the P9.4 had configured as general output.
Cancel
Vote up 0 Vote down

Cancel

Children

0 Vivek Tailor over 17 years ago in reply to John Brown

hello

I am bit confuse about the period. How can we generate 50micro second period using CAPCOM2 in XC164CS? Can anyone hwlp me plz?

Vivek
Cancel
Vote up 0 Vote down

Cancel
0 Vivek Tailor over 17 years ago in reply to Vivek Tailor

hello

Sorry above information is unclear. I just want to produce 50micro second period PWM or u can say 20Khz. What should be the timer reload value?

Vivek
Cancel
Vote up 0 Vote down

Cancel