Hello,
I use the Ulink2 jtag interface with the arm 20-pin connection. I have no possibility to use the RTCK Pin, so should I connect it with TDO, TCK or leave it unconnected?
http://www.keil.com/support/man/docs/ulink/ulink_hw_connectors.htm
Moreover I use pull-ups (10 kOhm) for NTRST, TDI, TMS and TDO - would that be ok?
best wishes Tina
ok I see...
when I take a look at the schematic of this board, the RCLK Pin is unconnected
http://www.keil.com/mcbstm32/mcbstm32-schematics.pdf
So I will it be unconnected to - if there are no problems with it