Keil forum XC2000 Âµvision3

State Not Answered
Locked Locked
Replies 4 replies
Subscribers 21 subscribers
Views 1322 views
Users 0 members are here

2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XC2000 Âµvision3

MOMO over 18 years ago

hello

I'm working on the ÂµC XC2000 for infineon.
My problem that I don't find the XC2000 in option for target 'Device' in Âµvision3.

is There any package to install, that Âµvision3 add in the device section the XC2000?

thanks

Parents

0 MOMO over 18 years ago in reply to Keil Software Support Intl.

Just I've little problem when adding the new device in the option to adjusting the CPU parameters for the XC2267.
where can I find these parameters
Cancel
Vote up 0 Vote down

Cancel

Reply

0 MOMO over 18 years ago in reply to Keil Software Support Intl.

Just I've little problem when adding the new device in the option to adjusting the CPU parameters for the XC2267.
where can I find these parameters
Cancel
Vote up 0 Vote down

Cancel

Children

0 rger koocer over 18 years ago in reply to MOMO

i want to get edgelib to work on the ST10

can you know how?

plz plz plz help me
Cancel
Vote up 0 Vote down

Cancel