Can anyone advise on their experience (good or bad) using an In Circuit Emulator with uVison 3 for the P89LPC935 and P89LPC936 microcontrollers. I am considering the Acqura PDS900 with a P89LPC936 bondout. Any information on your experience with this or another ICE would be welcome.
I got the Acqura and used it briefly before the LPC ran out of steam and was replaced by a 100MHz SILabs.
The ICE is very good, the documentation STINKS, the device can do so much (unneeded) stuff that the learning curve is quite steep.
However, I must praise the Acqura support. they WILL get you going. (IMHO the3 Acqura support is in the top 5)
Erik
Thanks Erik, that's very useful info. At this stage I have no feedback on other ICE's - looks like I will be grappling with some poor documentation (what's new?) but it is good to know the support is good.
EPM900 is an cost-effictive emulator for the LPC900 series. For more info see here:
http://www.keil.com/epm900/
Ceibo has one as well, I found it somewhat lacking compared to the Acqura but am still using it, for no other vreason than the interface is the sames as other Ceobo ICES.