This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

uvision3 debug mode

Hi All,

I do use uvision3 v3.51. i am loading code in RAM.In debug mode i add few varibles in Watch window.These variable are not recovered in watch window when i exit and reenter debug mode.Can anyone help me on this?

Thanks,
Dimple

Parents

0 Andy Neil over 18 years ago in reply to Dimple Bhana

Write a .INI file that sets-up the required watches, and specify this to be run whenever you start the debugger.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Andy Neil over 18 years ago in reply to Dimple Bhana

Write a .INI file that sets-up the required watches, and specify this to be run whenever you start the debugger.
Cancel
Vote up 0 Vote down

Cancel

Children

0 Dimple Bhana over 18 years ago in reply to Andy Neil

can you please tell me how exectly i can write .ini file for debugger??? i dont know how to do it!!

Thanks,
Dimple
Cancel
Vote up 0 Vote down

Cancel