• State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 20 subscribers
  • Views 3774 views
  • Users 0 members are here
Options
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Programming Failed!

Fei Huang

I am using STR750/Keil development kit. The JTAG programmer I am using is ULINK2. uVision3 Ver. 3.0.
Today I have problem to download program to the starter kit. It said "Erase Done, Programming Failed!".
I've tried two starter kits and same thing happened. Howerever, when I downloaded the program to my custom board, everything is okay. So ULINK2 should work fine.

I don't know what happened to the Keil Board. I checked the voltage, it was 3.3V. Anybody here has the clue. Thanks.

By the way, I tried to operate the UART, but I could not see the signal out from the port. I wonder whether Keil can provide some example codes.

Thanks again.
Fei

0