Hi all i wanted the FX2 to receive a 16 bit address (used to interface with labview)one eg is E012(one of the addressing i need to use), i am using the two registers I2CS and I2DAT. As u all know I2DAT is an 8 bit register as i am oso not sure wheather it is the correct step to write to I2DAT a 16 bit address when I2DAT only holds 8 bit. Or is there any other step, I wanted I2C to to write or read from (in my case labview) Please enlighten me thanks
The trolls may post totally 100% foolish posts. The problem is still that there are people who can't see the difference between good and bad advice, or good and bad source code examples. Ignoring the trolls would then result in beginners to spend significant time running fools errands...