Hi all i wanted the FX2 to receive a 16 bit address (used to interface with labview)one eg is E012(one of the addressing i need to use), i am using the two registers I2CS and I2DAT. As u all know I2DAT is an 8 bit register as i am oso not sure wheather it is the correct step to write to I2DAT a 16 bit address when I2DAT only holds 8 bit. Or is there any other step, I wanted I2C to to write or read from (in my case labview) Please enlighten me thanks
"i am using EZ-USB FX2 CY7C68013"
Wouldn't it have been so much easier if you had provided that information in the first place?!
"i will go take a look at the appnote again"
What appnote is that? If you provide a full reference - preferably with a link - people will be able to see what you're talking about.
Again, the more information you provide, the more likely you are to get good answers!
You also need to look at your Labview manuals to determine exactly how it sends this "16 bit address"...