Hi all i wanted the FX2 to receive a 16 bit address (used to interface with labview)one eg is E012(one of the addressing i need to use), i am using the two registers I2CS and I2DAT. As u all know I2DAT is an 8 bit register as i am oso not sure wheather it is the correct step to write to I2DAT a 16 bit address when I2DAT only holds 8 bit. Or is there any other step, I wanted I2C to to write or read from (in my case labview) Please enlighten me thanks
see; it were a easy guess to a person whot is profeshional!
The appnote i refer to is the EZ-USB FX2 Technical Reference Manual, it is in PDF format. this maneual can be found in google in the first link. My belongs to the 128 pin TQFP (thin quad flat pack). On page 289 to page 293. On page 292 is the steps i follow. After step 2 sending the slave address (in my case is EC) i need to send an sub address (which is E012, problem i faced) to FX2 that is the address location in labview. i have conplete all other steps (write & read) except the sub address part (not included in the steps) the ic which i am communicating to is AN32057A (it is an LED mangement IC)
"the ic which i am communicating to is AN32057A"
I thought you said you were interfacing with Labview?
So what's this LED chip? Manufacturer? Provide a link to the datasheet!
Either go and troll somewhere else, or at least spend some time and try to be a funny troll.
You mean this: download.cypress.com.edgesuite.net/.../ez_usb_r___technical_reference_manual__trm__14.pdf
yes?
That document isn't really what would usually be described as an "Application Note". An Application Note would illustrate how to Apply the part in a specific application.
What you really need is an application note that describes how to use the I2C controller...
Note that this has nothing to do with Keil software tools - have you tried asking Cypress about this?
see; it were a easy guess to a person whot is profeshional! guessing is easy knowing that you guessed right is impossible.
Erik
i know the guess was rite bcoz he says it is the one i guess it to!
i am instinkt and sure profeshionel
ah yes - the hallmarks of a professional.
Not!
u are v bad.
bcoz i got good ans and u wrong.
ha ha
I wonder if his code looks like this
4 ( ... ; ... ; ...) { whl (...) {
btw got above should be "guessed"
i gueddes it good
you guesedd it bad
who is profesihonal; arrrr
enough, you go ahead and guess for the rest of your life, I hope that when you guess wrong it will not harm anyone.
Your alter ego assumed that people guessed badly.
But a professional should not guess. They may form a hypothesis, and then try to verify it.
So, how long will you troll around, trying to play a not too bright 9-year-old? Don't you have anything creative to write?
A little (plagiarized) creative writing in the title ;)
On a serious note:
Why is it that the blatantly obvious troll posts trigger any response?
Surely the respondents realize that they are just feeding the idiot(s) desires.
Why is it that the blatantly obvious troll posts trigger any response? I guess to avoid the deaf being led by the blind as in http://www.keil.com/forum/docs/thread11650.asp .