This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AT91SAM7X128 don't run after reset

Hello, I have a problem with SAM7X128, I've made a simple program and it works fine (blinks LEDs...) but only as long as I don't switch the power off. After I reset the MCU by power down, it does nothing. When I download the program into the MCU againt (throug JTAG) it starts to work again (till I reset it again). The program runs on adresses about 0x00000500 so it is in FALSH nor RAM...

Thank You a lot, Mirek

0