He at All I have a big problem on board MCB2300 with LPC2368 When open the enviroment uVision and chk the ulink2 setting any time not show the "Jtag device chain" any time press more time the reset bottom the sistem work. But if load the program with flashmagic it work well erase load but after the program load example Blink not start , the dispaly show one row only but the program not run, any time the program start. what is this problem? The power is correct is 3,3 volt Franco
Check if the problem is caused by an incorrect MAM Timing setting.
Increase MAM Timing to 5 fetch cycles as explain here: http://www.keil.com/support/docs/3338.htm
I have chk the your infomation on the MAM timing and change it from 4 to 5 but the problem not delate. I have start other test an this is the response: I have use the flashmagic and have delete the all flash, after I have read the memory and is is all 0xFF, after load, the your program demo BLINK with flashmagic in flash and after chk wiht read comand if this program is load it is load. But the program not run the diaply is not initalinzing and if use the Jtag interface it not recognised, the Jtag Device chain is emty.
Sorry, but can you please try to explain your problem a bit better. I have serious problems to understand your English.
Have you modified the Blinky application, and changed the PLL settings?