Dear all, I want to start project with rgb led, what MCU i can use, ARM, AVR or PIC ? I have need 3 PWM Hardware not less than 10 Bit resolution, and eeprom memory inside mcu.
I must do 100% work myself.
Thank you for any comment or example similar project.
xgnetto
Please read the instructions on how to use formatting tags!
Q: "Is it a school requirement that you must modulate a RGB led using three PWM channels, or are the PWM channels expected to be used for something else"
A: "Yes"
'Yes' is not a meaningful answer to that question, is it?
It was not a Yes/No question - it was an either/or question, wasn't it?
"But remember I have need 3 PWM Hardware"
Do you? Why?
Read the question again, and answer it!
i say YES it is a school requirement and YES i Need THREE PCM channels
i need and RGB led for output
"i say YES it is a school requirement and YES i Need THREE PCM channels"
So you didn't read the question carefully, did you?
The questions was not "do you need 3 PCM channels" - it was "are the PWM channels expected to be used for something else"
It is very important that you read questions carefully - especially your assignments! It's no use handing-in a brilliant answer if it's to the wrong question!
As my maths teacher used to say, "If you can read, you're in!"