We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi All, I am facing software reset problem in the XC164.I am explaining the case in detail.Fortunately i am initialising three lEDS's on every powerUp.While during the execution of the application i observed that unfortunately sometimes that three LED's are getting glowed and off.I came to the conclusion that due to the reset i got that problem.Then i probed the problem and i made confirmation that there was no hardware reset.This is confirmed as the result of checking the hardware reset active low pin.If someone knows the reason,please help me.
Regards,Thangadurai.A
Hi, Actually i had disabled the watch dog.So i couldnt observe the SYSSTAT register.