c to assembly conversion

if you are not using keil
... then you are in the wrong forum

basically all the above is wrong
all you need is to use the SRC option (read the manual)

to Ashad
sinc u r llrgic t crtin chrctrs I will nt us thm. Whn rpling in frum, t lst gt th fcts stright

Erik

if you are not using keil
... then you are in the wrong forum

basically all the above is wrong
all you need is to use the SRC option (read the manual)

to Ashad
sinc u r llrgic t crtin chrctrs I will nt us thm. Whn rpling in frum, t lst gt th fcts stright

Erik

thanks Erik for your comments

thanks again for the SRC directive u suggested coz i never used it before.....

but i used the Assembly code option in the target window, also translate the C code in to assembly language line by line ....... in your method the assembly file is generated then again we have to compile it......... but when we select the assembly code listing option the ****.LST file is generated it is translated file line by line form C to assembly ........ that is why i choose this option

regards
Ashad Mustufa
mustufa66@hotmail.com

"in your method the assembly file is generated then again we have to compile it"

The original request was just to convert 'C' source code to assembler; that is exactly what the SRC directive does - nothing more, nothing less.

thanks Erik for your comments

thanks again for the SRC directive u suggested coz

I made it VERY CLEAR hoiw much I (and many others) DETEST the Stupid Monkey S*** and then you persist in using it with a thanks to me

Erik

Note
This message was edited because of rude or abusive language.