This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Could not stop ARM device! error

I tried to run a WebServer example from Keil on my non-Keil LPC2378 board. Since then, I am receiving Could not stop ARM device error when I try to program it with ULINK. I read in some other thread, that I should use ISP programming software, but even the bootloader isn't responding and I am receiving timeout errors. Is there anything I can do?

Parents

0 BHT BHT Medewerker over 18 years ago in reply to Keil Software Support Intl.

Thanks for your replies. I have downloaded the newest FlashMagic and followed the instructions from the link www.keil.com/.../mcb2300_fp_flash_alone.htm. I have checked my jumper settings, but still no luck. Any more ideas?

Thanks,
Marc
Cancel
Vote up 0 Vote down

Cancel

Reply

0 BHT BHT Medewerker over 18 years ago in reply to Keil Software Support Intl.

Thanks for your replies. I have downloaded the newest FlashMagic and followed the instructions from the link www.keil.com/.../mcb2300_fp_flash_alone.htm. I have checked my jumper settings, but still no luck. Any more ideas?

Thanks,
Marc
Cancel
Vote up 0 Vote down

Cancel

Children

No data