This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

MCB2300 Blinky example stuck in simulator

Has anybody figured out why the MCB2300 Blinky example project doesn't run in the simulator?
It gets stuck at line 376 of the startup code in LPC2300.s, where it's waiting for the osc to stabilize.

It's probably some PLL setting somewhere. I'm new to the LPC series.

Thanks.

0 Keil Software Support Intl. over 19 years ago

The LPC23xx device is not yet fully simulated. We are working on that.
Cancel
Vote up 0 Vote down

Cancel
0 Adriaan Verheij over 19 years ago in reply to Keil Software Support Intl.

Thanks for the quick answer.
When is the LPC23xx simulator expected to be finished?
Cancel
Vote up 0 Vote down

Cancel
0 Keil Software Support Intl. over 19 years ago in reply to Adriaan Verheij

Should come in March.
Cancel
Vote up 0 Vote down

Cancel
0 Robson Bandeira Sales over 19 years ago in reply to Keil Software Support Intl.

Have some prevision to release a version of the uvision which can emulate the LPC23xx? The last prevision is March.
Cancel
Vote up 0 Vote down

Cancel