Keil forum Can't debug LM3S811 EVAL BOARD from Luminary

State Not Answered
Locked Locked
Replies 3 replies
Subscribers 22 subscribers
Views 851 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't debug LM3S811 EVAL BOARD from Luminary

Viktor Bucher over 18 years ago

How to setup ULINK to debug that board ?

Parents

0 Viktor Bucher over 18 years ago in reply to Keil Software Support Intl.

Yes, the small board used in Circuit Cellar Contest. Do I need to make some modifications in the EVAL BOARD ?
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Viktor Bucher over 18 years ago in reply to Keil Software Support Intl.

Yes, the small board used in Circuit Cellar Contest. Do I need to make some modifications in the EVAL BOARD ?
Cancel
Vote up 0 Vote down

Cancel

Children

0 Viktor Bucher over 18 years ago in reply to Viktor Bucher

How can I configure the IDE to watch the hardware register in the memory window ? When debuging I canot see those register as memory locations.
Want to design my own board with Luminary device. Any recomendation for the JTAG interface circuit ?
Cancel
Vote up 0 Vote down

Cancel