My tool is LPC studio with 8K extension. When I run my program in simulating mode, CCU worked correctly. The registers in peripheral windows displayed as I set in program. When I run in emulating mdoe with EPM900, CCU seemed no action. CCU interrupt enable bit and registers were always unchanged no matter what value I loaded into register. Why did it happen?
oh~I see ^^.... The Bondout device in my EPM900 is P89LPC935FA. Sir, would you mind if I send some pictures clipped from uv3 screen to you ? Maybe there are some obvious errors you can see in my pictures.
Thanks!
willy