This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

I can download the program to MCU

I use LPC2468.

I has write some code to control PWM, and I set the PCON = 0x2, so the system enter power down mode, and then, I cann't download any program to this chip, because every time this board power up, it enter power down mode, so I cann't connect jtag. Anybody has any method to solve this problem?

Thanks in advacne.

Parents

0 Li Ying Hao over 18 years ago in reply to Robert Teufel

 Hello Robert:
    I have solved this problem. I connect P2.10 to GND before power up. the program in flash will not run, then I can download new program to this board.

Reply

0 Li Ying Hao over 18 years ago in reply to Robert Teufel

 Hello Robert:
    I have solved this problem. I connect P2.10 to GND before power up. the program in flash will not run, then I can download new program to this board.

Children

No data