hello everyone. i am learning 8051.
i want code for interfacing stepper motor with 8051 in assembly language and in "C" language can anyone help me????????
thank u.........
"go through the following book it will solved your all problem,
******The 8051 Microcontroller and Embedded System*** ************** Using assembly and c****************"
If you're going to recommend a book, be sure to give at least the Author(s).
A full citation should include the Publisher and ISBN.
There are booklists here: http://www.keil.com/books/8051books.asp www.8052.com/books.phtml
And here's a tutorial on the 8051: www.8052.com/tutorial.phtml
Don't forget the so-called "bible" for the 8051:
Chapter 1 - 80C51 Family Architecture: www.nxp.com/.../80C51_FAM_ARCH_1.pdf
Chapter 2 - 80C51 Family Programmer's Guide and Instruction Set: www.nxp.com/.../80C51_FAM_PROG_GUIDE_1.pdf
Chapter 3 - 80C51 Family Hardware Description: www.nxp.com/.../80C51_FAM_HARDWARE_1.pdf
sorry for the stupidity I did not mention the author and publication
here i mention MUHAMMAD ALI MAZIDI JANICE GILLISPIE MAZDI ROLIN D. McKINLAY
second edition PEARSON EDUCATION
here i mention MUHAMMAD ALI MAZIDI JANICE GILLISPIE MAZDI ROLIN D. McKINLAY second edition PEARSON EDUCATION
still an ancient text (copyright 2000).
Erik
I have not read the book, but i have read much by Craig Steiner and think his book might be a better choice.
you can get a glace at his style here www.8052.com/tutorial.phtml
"i have read much by Craig Steiner ... you can get a glace at his style here www.8052.com/tutorial.phtml "
And you can buy his book here: http://www.8052.com/book/