I am using IDE-Version:µVision3 V3.02. The controller I am using is DALLAS DS89C430.
When set target as DS89C430 and run the debug session in keil i am not able to see two serial ports in the peripheral drop menu. Also all the interrupts are not displayed.
But if i select the target device in keil as DS89C420(same family as DS89C430) then I am able to see two serial ports and all the interrupts present.
If you are having any updates pls send it to me on my e-mail. If possible pls send the steps to be followed while updating. i am in urget need.
Thankyou Avishek kumar