I have problems to get the CAN controller on my Infineon XC886 CM running. Have someone example code for sending a CAN message via CAN node 0 (CAN RXD Port 1_6, CAN TXD Port 1_7)? I have tryed to use Dave-generated code with the following code in my main-function:
un_32bit canTestObject;
canTestObject.ubDB[0] = 0x77; canTestObject.ubDB[1] = 0x76; canTestObject.ubDB[2] = 0x75; canTestObject.ubDB[3] = 0x74;
CAN_vLoadData(0x00, &canTestObject.ulVal); CAN_vSetMSGVAL(0x00); CAN_vTransmit(0x00);
But it only works in the software-simulator (in der Peripherals->MultiCAN->CAN Communication 0 window the sended messages appear) but not on my self-made board (nothing to see with oscilliscope on the MCU-Pins 1_6 and 1_7).
Another one for the list of reasons why something might work in simulation, but not in real life:
* You have misunderstood the way some external device works, so your software is based on this misunderstanding and your simulation is based on the same misunderstanding - hence they work together in simulation, but not with the real behaviour of a real device in real life!