While trying to interface flash SST25VF512 with AT80c51, i find difficulty in Byte program mode of writing to flash.
This is the code i used, could somebody who has worked on this please help me out,
void main(void){ ce = 1; SCK = 0; TMOD = 0x20; TH1 = -3; // 9600 baud SCON = 0x50; TR1 = 1; TI = 1; addr = 0x00000012; Rd_ID = Read_ID(); Byte_Program(addr); void Byte_Program(unsigned long addr){ ce = 0; E_WRSR(); WREN(); Send_Byte(0x02); // Byte Program CMD Send_Byte(((addr & 0xFFFFFF) >> 16)); // sending 3 address bytes Send_Byte(((addr & 0xFFFF) >> 8)); Send_Byte(addr & 0xFF); Send_Byte(0x10); //send data SR_byte = Read_Status_Register(); while((SR_byte &0x01) != 0x00){ SR_byte = Read_Status_Register(); } ce = 1; } void E_WRSR(){ ce = 0; Send_Byte(0x50); // enable Status Reg ce = 1; ce = 0; Send_Byte(0x01); // select write to status register Send_Byte(0x00); // mode 0, ce = 1; } void WREN(){ ce = 0; Send_Byte(0x06);// to Write enable ce = 1; } unsigned char Get_Byte(){ unsigned char i=0, in=0, temp=0; for(i=0;i<8;i++){ in = (in << 1); temp = SO; SCK = 1; if (temp == 1){ in = in | 0x01; } SCK = 0; } return in; } void Send_Byte(unsigned char b_out){ for(i=0;i<8;i++){ if((b_out & 0x80) == 0x80) si = 1; else si = 0; SCK = 1; b_out = (b_out << 1); SCK = 0; } }
Thanks in advance,
"Could you please tell this rated number of cycles."
That'll be in the datasheet
Note that it is not a precise number below which everything is fine and above which nothing works; the thing wears out gradually.
Thanks Neil, How do you say the write function code should be, After writing the byte, the status reg reads 02, ie finished writing. Then should there be some change in the read function code? Where do you think is the mistake,
"How do you say the write function code should be"
Never mind what I say - what does the Manufacturer say?
Don't SST provide example code for this?
If that had worked, would not have asked you
Had followed the manufacturer's code supposedly there are fine changes to be done thought you got an eye for detail SST does provide code, though there are things to be added to it like Enable operation etc..