Using STR730 ARM, The EIC peripheral window incorrectly shows flags in the interrupt Enable Registers EIC_IER0 and EIC_IER1.
In simulation, selecting the channel then toggling the 'Enable' tick box, the EIC registers seem to behave ok.
However, when connected to ULink and target hardware, the interrupts 32 and above should reflect in EIC_IER1, yet when the tick box is toggled they incorrectly affect EIC_IER0.
When running a program the Interrupt Enable flags ( 32 and above ) were not seen to show in the EIC peripheral debug window.
Keil please confirm, and advise. Using latest mdk302a download version.