Good days! Sorry. I work with Keil .Vision3 V3.30a. Have some C8051F060 devices. When processing my programms under Debuger control don't have any problems. But after device FLASH programming and abort Debug Session I get some problem. When read microprocessor input ports I get not correct information about input signals. What is it?
Thank You! Sasha, Ukraine.
Thank You.
I running program at full speed when using the debugger. But I use interrupts. I am sure (I think so) that the code in the Flash is exactly the same as the code that was running under debug.
You says: "...Do you leave the debugger cable attached even when the code is running in non-debug mode? Maybe there is some interaction with the "idle" signals on the debug cable? Or a grounding issue?..."
It's most unknown moments for me, because I am't hardware specialist. it's seems to me that in non-debug mode programm don't work correct any with the debugger cable or without.