This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

The advanced RTX peripherals can't show all active task.

I'm using ARTX os.
When i open the Advanced RTX peripheral dialog, in active tasks tab,there show only os_clock_demon. but in systemtab, show 2 actived task of 6 available .
In fact, i created 2 task.

Can you tell me what happened.

thanks.

Parents

0 lx leng over 19 years ago in reply to Keil Software Support Intl.

Thanks for your reply.
I found when i choseuse thumb mode,
i can use it fine.
If i compile file ARTX_config.cuse ARMdirective,the problem appeared.

My uvison ver: 2.23
c compiler ver : 2.42
Cancel
Vote up 0 Vote down

Cancel

Reply

0 lx leng over 19 years ago in reply to Keil Software Support Intl.

Thanks for your reply.
I found when i choseuse thumb mode,
i can use it fine.
If i compile file ARTX_config.cuse ARMdirective,the problem appeared.

My uvison ver: 2.23
c compiler ver : 2.42
Cancel
Vote up 0 Vote down

Cancel

Children

0 Richard Purvey over 19 years ago in reply to lx leng

Has this problem been resolved as I have the same issue?
Cancel
Vote up 0 Vote down

Cancel