I have an xdata question and please excude my lack of knowledge on this subject, I have been trying to find info on this and am just not getting anywhere. I am using a Goal VRS1000 controller. It has 64K of flash and 1K of RAM. I have not enabled the upper 756K of the RAM. The issue I am running into on my device is, when I go over 769 bytes of xdata my device fails to boot correctly. I have been trying to find out where exactly this xdata is being stored. Since I have not enabled the full range of the on-chip RAM, I am a little confused where it is stored. Thanks for the help.
Finally the answer comes to me. I never even looked at the reset value before. This is were the XRAM is being enabled. Thanks for al lthe help everyone.