This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Application for PRAM ( CAN BUS Bootoader )

I'm working on a project where I need to upload the firmware from CAN BUS line ( automotive application ) . I must do it using the BOOTOLOADER started in "CAN Mode" .
My problem is how to say to uVision to compile the code and link it for PRAM destination , and say to uVision to upload it on PRAM other than intenal FLASH . Do anyone already worked on similar project ?

Thanks

Parents Reply Children
No data