This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Help needed in LCD interfacing .... (this time in right place) lolz

I am new to AVR Programming and i have made my scope of study on 8051 family. i have made a project on UART , my MCU is connected to the PC via MAX232 but my probelem is that i have only free ports from P1.0 to P1.7 and two of P3 pins and i want to use the LCD for output so cud any one please help me little for LCD interfacing to my available pins and program for it in KEIL.

Hello .... i know i have made mistake cuz i didnt have to post my thread for C251 well sorry again cuz i have misplaced it .... the hole story is that i am using AT89C4051, (Default) and i can use it on my uVision2 with the AT89C51 but the problem is that i know about the interfacing the LCD with 8 bit and 4 bit but the problem is that i dont understand the ASM and the mostly code found on the internet is in ASM so could any one please help me ...?

Parents Reply Children
No data