Hi, I am generating pulse output through 8051 microcontroller using assembly langauge. I don't wnat to use any timer for time delay, I would like to use instruction delays as follows... CLR portbit......3 cycles NOP..............1 cycle NOP..............1 cycle NOP..............1 cycle SETB portbit.....3 cycles NOP..............1 cycle NOP..............1 cycle NOP..............1 cycle CLR portbit......3 cycles 6cycles ---| |-------| |-------| | 6cycles OFF time = 1+1+1+3 ON time = 1+1+1+3 Is it my calculation is correct here?. SETB portbit.....3 cycles will be added into OFF time or ON time? Please comment on this... Thanks in advance Rajesh
Erik, I am sorry I didn't get why u mensioned "micro" in ur message? If u want to give explaination otherthan technical, please give me ur email id I will continue to mail u directly instead of wasting the space on this forum. I have lot of respect on the people who works for the forum to give stright technical answers. Thanks in advance
I am sorry I didn't get why u an abbreviation for micro mensioned "micro" in ur an abbreviation for micro resistor message? If u an abbreviation for micro want to give explaination otherthan technical, please give me ur an abbreviation for micro resistor email id I will continue to mail u an abbreviation for micro directly instead of wasting the space on this forum. I have lot of respect on the people who works for the forum to give stright technical answers. So reading the above as something related to the '51 does not make one bit of sense THIS IS NOT A FRIGGIN CELLPHONE MESSAGE IT IS A COMPUTER FORUM POST Erik