Hi all, I need a help urgently here. I am currently doing the RF transmitter and receiver project. Whenever the receiver is detecting the range from the trasnmitter is at certain range, an alarm would be trigger on. I am using the Easy radio transmitter and receiver ER900TS and ER900RS. The problem now is i dont know how to get started to write the C codes for them to communicate. Hope you guys can reply soon. Thanks.
Thanks for the reply and sorry if i was entering the wrong forum. I really need some help on that.I dont have enough budget to buy the full evaluation kits. I using microcontroller to control both units. My doubt is that the Er commands that stated in the datasheets is it the same command lines that needed to assert in the programs to communicate btw 2 modules? Or is it just references? then, we can set them manually using microcontroller UART programs? Thanks
I using microcontroller to control both units. My doubt is that the Er commands that stated in the datasheets is it the same command lines that needed to assert in the programs to communicate btw 2 modules? Which microcontroller which 2 modules
I am using Atmel 89C52. The 2 modules i meant is transmitter ER900TS, and receiver ER900RS from easy radio.
"The 2 modules i meant is transmitter ER900TS, and receiver ER900RS from easy radio." They are not "from" Easy Radio - that is their brand name. They are "from" LPRS; Low Power Radio Solutions Limited: http://www.lprs.co.uk/about/index.php?language_id=1 For specific questions about their products, you need to contact LPRS. Contact details are on their web site: http://www.lprs.co.uk/faqs/support.php If you bought through a local distributor, you should try their support first.