I am trying to troubleshoot a project containing 2 targets which communicate over a CAN bus on Si Labs' C8051F04x CPUs with Keil's uVision3 environment. When running in edit mode, I can always see which target is active by looking at the selection line in the Build toolbar. But when I switch to debug mode, the toolbar disappears and I have found no way to tell which target is active. I have already loaded code into the wrong board once, and worry how well I will be able to keep track of it when I may have to switch among 5 targets. Has anyone figured out a way to tell them apart (other than switching to Edit mode & back again)? Thanks. ============================================================ Gary Lynch | To send mail, change no$pam in lynchg@no$pam.com | my domain name to stacoenergy
You are right! Herzlichsten Dank! ============================================================ Gary Lynch | To send mail, change no$pam in lynchg@no$pam.com | my domain name to stacoenergy