This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Example for AT91EB40 with and without Angel Debug Monitor

Dirk S over 19 years ago

I know, that Keil ARM supports debugging
over jtag f.e. with Ulink.

Exists in ARM Keil a debug solution for using the Angel
Debug Monitor on the serial port for the Atmel evaluation boards like AT91EB40, AT91EB40a ?

Are the any examples for using the AT91EB40 with Keil ?
The AT91EB40a is different against the AT91EB40 from the microcontroller type and the memmory parts placed on the board.

Parents

0 Keil Software Support Intl. over 19 years ago

You may debug this device using ULINK. A project example is in the folder:

C:\Keil\ARM\RV30\Boards\Atmel\EB40A\Hello
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Keil Software Support Intl. over 19 years ago

You may debug this device using ULINK. A project example is in the folder:

C:\Keil\ARM\RV30\Boards\Atmel\EB40A\Hello
Cancel
Vote up 0 Vote down

Cancel

Children

No data