This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

A question about XC167CI simulator speed

Hello all,
I have used dave to setup a CPU speed to 20Mhz, by

PLLCON         =  0x7814;      // load PLL control register

To my surprise, while simulating a XC167CI, an interrupt that was programmed to occur every 5[ms] actually occured every 1[ms]. setting the CLKCFG did not have any effect (while simulating a XC167CR was influeced by the XTAL setting). is there another element that I should have setup besides PLLCON?

Parents

0 Tamir Michael over 19 years ago in reply to Andy Neil

Hello Andy,
thanks for your reply. The thing is, that when I ran the program on a XC167CR simulator it did produce 5[ms] interval interrupts :)...
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Tamir Michael over 19 years ago in reply to Andy Neil

Hello Andy,
thanks for your reply. The thing is, that when I ran the program on a XC167CR simulator it did produce 5[ms] interval interrupts :)...
Cancel
Vote up 0 Vote down

Cancel

Children

0 Andy Neil over 19 years ago in reply to Tamir Michael

Luck was being a lady for you, then...
Cancel
Vote up 0 Vote down

Cancel