Hi, i have to develop a configuration control for a microcontroller. For this i developd GUI using VC++ and µc controller programs are written in Keil. I have to send data from GUI to µc programs which are written in keil, where both programs are running on same pc.But i am not able to make communication between VC and µc, and i got an idea that can i write keil programs in VC, then i did that but vc is not supportng data types of keil, is it possible to write c51 in vc compiler? Thanking you
"data in GUI hast to send to µvision programs at run time, and receive some data from µvision." What data do you want to send to uVision? What do you want uVision to do with it? What data do you want uVision to send to MSVC?
HI, i will explain my whole work. We are working on wireless senseors, in this we wanted to send some data through sensors between two pc's. Each pc is connected with microcontroller and microcontroller programs are written in keil in pc, before we had to write the data which should send by microcontroller in keil ,and if we had to send some other data or new data we had to write that in keil program and we had to send that, but now we want that user can send data without opeening keil program everytime, so i developed a GUI in MSVC and in that we made buttons to set intial vallues for keil programs, so that user can set intial values and send data to µvision keil programs at run time. To this we have to make communication between keil and msvc. so that user can set , control µvision program via GUI. And in another side µvision has to give acknowledgement to GUI that user can do further steps. I hope you understand what i need. Thanking you with regards sheshidar
"we wanted to send some data through sensors between two pc's." I think we have a language problem here: you don't send data through a sensor - a sensor measures some physical quantity and generates the corresponding data. Are you trying to simulate a sensor? Or do you not mean "sensor" at all?
Hi i just said that about sensors, actually my task is upto make communication between keil and msvc. But i am not getting how to setup the communication between both.
"i just said that about sensors" So how about describing what you're really trying to achieve? I fear that there is a language barrier here, and this discussion is fruitless. Can you find a local consultant or expert to discuss in your own language? eg, http://www.keil.com/condb/